The image was printed off then cut out with a 1.75" Nestability square
The Nestie scallop was cut out of Lavender Lace. The image was colored with Copic markers. Glitter was added to the cupcake.
To decorate the front of the card I embossed both the green cs and the dp on the lower section with a Cuttlebug embossing folder. A Martha Stewart punch was used for the fence border. The fence was layered on the lavender cs then topped with the embossed design paper. A flower and bow were added to complete the card. The two front pieces were placed over the back piece then a brad added for the hinge. Only the lower portion of the card was attached to the back. The adhesive was added below the brad across the top; down the sides and along the bottom. You need the top portion of this piece open so the top can slide behind it to close.
The bunny image was attched after the card was complete. Dimensional tape was added on the middle and top portion of the back of the image. The tape should be even with the bottom portion of the card so the card closes in the right position. I then stamped the verse (GKD) on the inside.
The tutorial I found on how to create this type card can be found here.
I appreciate you stopping by.